Ensurepass  QUESTION 221 Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?     A.      data link layer B.      application layer C.      access layer D.      session layer E.       network layer   Correct Answer: E     QUESTION 222 Refer to the exhibit. Read more [...]
Ensurepass  QUESTION 211 Which statement about access lists that are applied to an interface is true?   A.      You can place as many access lists as you want on any interface. B.      You can apply only one access list on any interface. C.      You can configure one access list, per direction, per Layer 3 protocol. D.      You can apply multiple access lists with the same protocol or in Read more [...]
Ensurepass  QUESTION 201 Drag and Drop   Correct Answer:             QUESTION 202 Refer to the exhibit. A junior network administrator was given the task of configuring port security on SwitchA to allow only PC_A to access the switched network through port fa0/1. If any other device is detected, the port is to drop frames from this device. The administrator configured the interface and tested it with successful pings from PC_A to RouterA, and then observes Read more [...]
Ensurepass  QUESTION 181 Which command shows your active Telnet connections?   A.      show cdp neigbors B.      show session C.      show users D.      show vty logins   Correct Answer: B       QUESTION 182 Which type of EIGRP route entry describes a feasible successor?   A.      a backup route, stored in the routing table B.      Read more [...]
Ensurepass  QUESTION 191 What are two benefits of using NAT? (Choose two.)   A.      NAT facilitates end-to-end communication when IPsec is enabled. B.      NAT eliminates the need to re-address all hosts that require external access. C.      NAT conserves addresses through host MAC-level multiplexing. D.      Dynamic NAT facilitates connections from the outside of the network. E.       Read more [...]
Ensurepass  QUESTION 161 Refer to the exhibit. A network administrator configures a new router and enters the copy startup-config running-config command on the router. The network administrator powers down the router and sets it up at a remote location. When the router starts, it enters the system configuration dialog as shown. What is the cause of the problem?     A.      The network administrator failed to save the configuration. B.      Read more [...]
Ensurepass  QUESTION 171 Which two locations can be configured as a source for the IOS image in the boot system command? (Choose two.)   A.      RAM B.      NVRAM C.      flash memory D.      HTTP server E.       TFTP server F.       Telnet server   Correct Answer: CE     QUESTION 172 Refer to the exhibit. Given the Read more [...]
Ensurepass  QUESTION 151 If IP routing is enabled, which two commands set the gateway of last resort to the default gateway? (Choose two.)   A.      ip default-gateway 0.0.0.0 B.      ip route 172.16.2.1 0.0.0.0 0.0.0.0 C.      ip default-network 0.0.0.0 D.      ip default-route 0.0.0.0 0.0.0.0 172.16.2.1 E.       ip route 0.0.0.0 0.0.0.0 172.16.2.1   Correct Read more [...]
Ensurepass  QUESTION 141 What is a global command?   A.      a command that is set once and affects the entire router B.      a command that is implemented in all foreign and domestic IOS versions C.      a command that is universal in application and supports all protocols D.      a command that is available in every release of IOS, regardless of the version or deployment status E.       Read more [...]
Ensurepass  QUESTION 131 Refer to the exhibit. The speed of all serial links is E1 and the speed of all Ethernet links is 100 Mb/s. A static route will be established on the Manchester router to direct traffic toward the Internet over the most direct path available. What configuration on the Manchester router will establish a route toward the Internet for traffic that originates from workstations on the Manchester LAN?   A.      ip route 0.0.0.0 255.255.255.0 172.16.100.2 Read more [...]