Ensurepass    QUESTION 221 Refer to the exhibit. An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?     A.      data link layer B.      application layer C.      access layer D.      session layer E.       network layer   Correct Answer: E     QUESTION 222 Refer to Read more [...]
Ensurepass  QUESTION 211 Which statement about access lists that are applied to an interface is true?   A.      You can place as many access lists as you want on any interface. B.      You can apply only one access list on any interface. C.      You can configure one access list, per direction, per Layer 3 protocol. D.      You can apply multiple access lists with the same protocol or in Read more [...]
Ensurepass  QUESTION 201 Drag and Drop   Correct Answer:             QUESTION 202 Refer to the exhibit. A junior network administrator was given the task of configuring port security on SwitchA to allow only PC_A to access the switched network through port fa0/1. If any other device is detected, the port is to drop frames from this device. The administrator configured the interface and tested it with successful pings from PC_A to RouterA, and then observes Read more [...]
Ensurepass  QUESTION 191 What are two benefits of using NAT? (Choose two.)   A.      NAT facilitates end-to-end communication when IPsec is enabled. B.      NAT eliminates the need to re-address all hosts that require external access. C.      NAT conserves addresses through host MAC-level multiplexing. D.      Dynamic NAT facilitates connections from the outside of the network. E.       Read more [...]
Ensurepass  QUESTION 181 Which command shows your active Telnet connections?   A.      show cdp neigbors B.      show session C.      show users D.      show vty logins   Correct Answer: B       QUESTION 182 Which type of EIGRP route entry describes a feasible successor?   A.      a backup route, stored in the routing table B.      Read more [...]
Ensurepass  QUESTION 161 Refer to the exhibit. A network administrator configures a new router and enters the copy startup-config running-config command on the router. The network administrator powers down the router and sets it up at a remote location. When the router starts, it enters the system configuration dialog as shown. What is the cause of the problem?     A.      The network administrator failed to save the configuration. B.      Read more [...]
Ensurepass  QUESTION 171 Which two locations can be configured as a source for the IOS image in the boot system command? (Choose two.)   A.      RAM B.      NVRAM C.      flash memory D.      HTTP server E.       TFTP server F.       Telnet server   Correct Answer: CE     QUESTION 172 Refer to the exhibit. Given the Read more [...]
Ensurepass  QUESTION 141 What is a global command?   A.      a command that is set once and affects the entire router B.      a command that is implemented in all foreign and domestic IOS versions C.      a command that is universal in application and supports all protocols D.      a command that is available in every release of IOS, regardless of the version or deployment status E.       Read more [...]
Ensurepass  QUESTION 151 If IP routing is enabled, which two commands set the gateway of last resort to the default gateway? (Choose two.)   A.      ip default-gateway 0.0.0.0 B.      ip route 172.16.2.1 0.0.0.0 0.0.0.0 C.      ip default-network 0.0.0.0 D.      ip default-route 0.0.0.0 0.0.0.0 172.16.2.1 E.       ip route 0.0.0.0 0.0.0.0 172.16.2.1   Correct Read more [...]
Ensurepass  QUESTION 121 The network administrator is asked to configure 113 point-to-point links. Which IP addressing scheme defines the address range and subnet mask that meet the requirement and waste the fewest subnet and host addresses?   A.      10.10.0.0/16 subnetted with mask 255.255.255.252 B.      10.10.0.0/18 subnetted with mask 255.255.255.252 C.      10.10.1.0/24 subnetted with mask 255.255.255.252 D.      Read more [...]
Ensurepass  QUESTION 131 Refer to the exhibit. The speed of all serial links is E1 and the speed of all Ethernet links is 100 Mb/s. A static route will be established on the Manchester router to direct traffic toward the Internet over the most direct path available. What configuration on the Manchester router will establish a route toward the Internet for traffic that originates from workstations on the Manchester LAN?   A.      ip route 0.0.0.0 255.255.255.0 172.16.100.2 Read more [...]
Ensurepass    QUESTION 111 Refer to the exhibit. What is the most efficient summarization that R1 can use to advertise its networks to R2?     A.      172.1.0.0/22 B.      172.1.0.0/21 C.      172.1.4.0/22 D.      172.1.4.0/24 172.1.5.0/24 172.1.6.0/24 172.1.7.0/24 E.       172.1.4.0/25 172.1.4.128/25 172.1.5.0/24 172.1.6.0/24 172.1.7.0/24   Correct Read more [...]
Ensurepass HOT EXAM! 100-105 Dumps VCE PDF 200-105 Dumps VCE PDF 300-101 Dumps VCE PDF 300-115 Dumps VCE PDF 300-135 Dumps VCE PDF 300-320 Dumps VCE PDF 400-101 Dumps VCE PDF 640-911 Dumps VCE PDF 640-916 Dumps VCE PDF 70-410 Dumps VCE PDF 70-411 Dumps VCE PDF 70-412 Dumps VCE PDF 70-413 Dumps VCE PDF 70-414 Dumps VCE PDF 70-417 Dumps VCE PDF 70-461 Dumps VCE PDF 70-462 Dumps VCE PDF 70-463 Dumps VCE PDF 70-464 Dumps VCE PDF 70-465 Dumps VCE PDF 70-480 Dumps VCE PDF 70-483 Read more [...]
Ensurepass  QUESTION 101 What is the alternative notation for the IPv6 address B514:82C3:0000:0000:0029:EC7A:0000:EC72?   A.      B514 : 82C3 : 0029 : EC7A : EC72 B.      B514 : 82C3 :: 0029 : EC7A : EC72 C.      B514 : 82C3 : 0029 :: EC7A : 0000 : EC72 D.      B514 : 82C3 :: 0029 : EC7A : 0 : EC72   Correct Answer: D   QUESTION 102 Refer to the diagram. All hosts have connectivity Read more [...]
Ensurepass  QUESTION 71 Which three of these statements regarding 802.1Q trunking are correct? (Choose three.)   A.      802.1Q native VLAN frames are untagged by default. B.      802.1Q trunking ports can also be secure ports. C.      802.1Q trunks can use 10 Mb/s Ethernet interfaces. D.      802.1Q trunks require full-duplex, point-to-point connectivity. E.       Read more [...]
Ensurepass  QUESTION 81 Refer to the exhibit. A technician is troubleshooting host connectivity issues on the switches. The hosts in VLANs 10 and 15 on Sw11 are unable to communicate with hosts in the same VLANs on Sw12. Hosts in the Admin VLAN are able to communicate. The port-to-VLAN assignments are identical on the two switches. What could be the problem?     A.      The Fa0/1 port is not operational on one of the switches. B.      Read more [...]
Ensurepass  QUESTION 61 Refer to the exhibit. Which statement is true?     A.      The Fa0/11 role confirms that SwitchA is the root bridge for VLAN 20. B.      VLAN 20 is running the Per VLAN Spanning Tree Protocol. C.      The MAC address of the root bridge is 0017.596d.1580. D.      SwitchA is not the root bridge, because not all of the interface roles are designated.   Correct Read more [...]
Ensurepass  QUESTION 51 Assuming the default switch configuration, which VLAN range can be added, modified, and removed on a Cisco switch?   A.      1 through 1001 B.      2 through 1001 C.      1 through 1002 D.      2 through 1005   Correct Answer: B     QUESTION 52 Which statement about VLAN operation on Cisco Catalyst switches is true?   A.      Read more [...]
Ensurepass  QUESTION 21 Host 1 is trying to communicate with Host 2. The e0 interface on Router C is down. Which of the following are true? (Choose two.)     A.      Router C will use ICMP to inform Host 1 that Host 2 cannot be reached. B.      Router C will use ICMP to inform Router B that Host 2 cannot be reached. C.      Router C will use ICMP to inform Host 1, Router A, and Router B that Host 2 cannot be Read more [...]
Ensurepass  QUESTION 31 What value is primarily used to determine which port becomes the root port on each nonroot switch in a spanning-tree topology?   A.      path cost B.      lowest port MAC address C.      VTP revision number D.      highest port priority number E.       port priority number and MAC address   Correct Answer: A   QUESTION 32 In Read more [...]
Ensurepass  QUESTION 41 Refer to the exhibit. A technician has installed SwitchB and needs to configure it for remote access from the management workstation connected to SwitchA. Which set of commands is required to accomplish this task?     A.      SwitchB(config)# interface FastEthernet 0/1 SwitchB(config-if)# ip address 192.168.8.252 255.255.255.0 SwitchB(config-if)# no shutdown   B.      SwitchB(config)# interface vlan 1 SwitchB(config-if)# Read more [...]
Ensurepass  QUESTION 11 Which three statements accurately describe Layer 2 Ethernet switches? (Choose three.)   A.      Spanning Tree Protocol allows switches to automatically share VLAN information. B.      Establishing VLANs increases the number of broadcast domains. C.      Switches that are configured with VLANs make forwarding decisions based on both Layer 2 and Layer 3 address information. D.      Read more [...]
Ensurepass  QUESTION 1 Refer to the exhibit. What will Router1 do when it receives the data frame shown? (Choose three.)     A.      Router1 will strip off the source MAC address and replace it with the MAC address 0000.0c36.6965. B.      Router1 will strip off the source IP address and replace it with the IP address 192.168.40.1. C.      Router1 will strip off the destination MAC address and replace it with Read more [...]