Joe, a network administrator, has been requested to install wireless access throughout the entire building, while utilizing a single SSID. Which of the following options will meet this requirement?


A.      Set a separate VLAN on each WAP with the same encryption type

B.      Set the SSID on each WAP and set contiguous WAPs to different channels

C.      Set the SSID on each WAP and set contiguous WAPs to the same channel

D.      Set a separate VLAN on each WAP with the same frequency


Correct Answer: B




Which of the following connectors would Karen, a technician, use only for RG-6 cables?


A.      F-connector

B.      MTRJ

C.      RJ-45

D.      RS-232


Correct Answer: A




Which of the following allows for multiple operating systems to be run simultaneously on a single server?


A.      Dual boot

B.      Multiple hard drives

C.      PXE boot

D.      Virtual machines


Correct Answer: D




Sandy, a network technician, would like to keep the IP address of the Human Resource department” s server in the same group of 100 DHCP IP addresses that are assigned to the Human Resource department’s employee workstations. Which of the following would BEST allow this and have the ability for the server to keep the same IP address?


A.      Implement a set of static IPs for the entire human resource department.

B.      Use a DHCP reservation for the server IP address.

C.      Use a small DHCP scope for the human resource department.

D.      Connect the server to a router in the network closet on the same floor.


Correct Answer: B




Which of the following wireless network standards allows for the HIGHEST speeds?


A.      802.11a

B.      802.11b

C.      802.11g

D.      802.11n


Correct Answer: D




Sandy, a network technician, needs to push changes out to network devices and also monitor the devices based on each device’s MIB. Which of the following should she use?


A.      SNMP

B.      Traffic analysis

C.      Syslog

D.      Asset management


Correct Answer: A




Which of the following would Joe, a technician, MOST likely use to remotely verify port configuration of a switch?


A.      traceroute command

B.      SNMP monitor

C.      nbtstat command

D.      dig command


Correct Answer: A




Which of the following can be used to view the list of ports on which a server is listening?


A.      dig

B.      net statistics

C.      netstat

D.      nslookup


Correct Answer: C




Which of the following protocols uses port 3389?


A.      IMAP

B.      DHCP

C.      SSH

D.      RDP


Correct Answer: D




Sandy, a technician, needs to customize various cable lengths and verify that the cables are working correctly. Which of the following tools would be needed to accomplish this? (Select TWO).


A.      Cable certifier

B.      Multimeter

C.      Crimper

D.      Punch down tool

E.       Loopback plug


Correct Answer: AC



Comments are closed.