Ensurepass

QUESTION 531

Which of the following memory types is MOST commonly found in Pentium 4 class and newer

desktop PCs?

 

A.      SIMM

B.      RAMBUS

C.      SODIMM

D.      DIMM

 

Correct Answer: C

 

 

QUESTION 532

A laptop’s wireless card shows up in the Device Manager, but the signal strength is always one

bar. This is caused by which of the following?

 

A.      The signal is disabled in the wireless utility.

B.      Disconnected or broken antenna.

C.      Disconnected or broken inverter.

D.      The wireless switch is turned off.

 

Correct Answer: B

 

 

QUESTION 533

DRAG DROP

clip_image002

 

Correct Answer:

clip_image004

 

 

QUESTION 534

DRAG DROP

clip_image006

 

Correct Answer:

clip_image008

 

 

QUESTION 535

HOTSPOT

clip_image010

 

Correct Answer:

clip_image012

 

 

QUESTION 536

DRAG DROP

Drag the components from the list and place them in correct devices.

clip_image014

 

Correct Answer:

clip_image016

 

 

QUESTION 537

DRAG DROP

clip_image018

 

Correct Answer:

clip_image020

 

 

QUESTION 538

A first time PC owner drops off their brand new PC for service, reporting that it is slow and the

memory should be 12GB according to the box but only reports 4GB. The RAM voltage was set

improperly; one chip needed to be reseated and the BIOS had to be set to use the triple channel

architecture. When picking up the PC the customer asks what was wrong. Which of the following

would be the MOST appropriate response for this customer?

 

A.      “Your PC’s memory was installed incorrectly. I removed it and put it back in. Additionally the

XMP profile needed to be adjusted for TCA.”

B.      “It was very complicated and technical in nature. If you do not mess with the settings, it

should be fine from now on.”

C.      “You had the DDR3-1600 set up wrong; you set it for 1.5v and single channel.”

D.      “The PC’s memory, or RAM, needed to have the correct settings applied to be utilized

correctly. It should work fine now.”

 

Correct Answer: D

 

 

QUESTION 539

A technician would like to load an operating system CD on startup. Which of the following

settings would a technician change in the BIOS?

 

A.      Enable TPM

B.      Enable BIOS password

C.      Disable TPM

D.      Boot sequence

 

Correct Answer: D

 

 

QUESTION 540

During which of the following phases of the imaging process is the latent image exposed to

toner?

 

A.      Charging

B.      Developing

C.      Exposing

D.      Transferring

 

Correct Answer: B

 

Comments are closed.