Ensurepass   QUESTION 291 Refer to the Exhibit. Routers in the Diagram are configured with EIGRP. If RTB and RTC fail, which action will RTA take with respect to the HQ network?   A.       RTA will automatically route packets via RTD to the HQ network. B.       RTA will place the route via RTD into the hold down state. C.       RTA will go into the active state for all routers. D.      RTA will go into the active state for the route to HQ network.   Answer: D     QUESTION Read more [...]
Ensurepass  QUESTION 281 Click and drag the associated EIGRP functionality on the left to the corresponding topology characteristic on the right.   Answer:     QUESTION 282 Which two statements about 6to4 tunneling are accurate? (Choose two.)   A.       Prepending a reserved IPv6 code to the hexadecimal representation of 192.168.0.1 facilitates 6to4 tunneling. B.       Each 6to4 site receives a /48 prefix in a Read more [...]
Ensurepass  QUESTION 271 When policy-based routing (PBR) is being configured, which three criteria can the set command specify? (Choose three.)   A.  all interfaces through which the packets can be routed B.  all interfaces in the path toward the destination C.  adjacent next hop router in the path toward the destination D.  all routers in the path toward the destination E.  all networks in the path toward the destination F.  type of service and precedence Read more [...]
Ensurepass  QUESTION 261 An IPv6 overlay tunnel is required to communicate with isolated IPv6 networks across an IPv4 infrastructure. There are currently five IPv6 overlay tunnel types. Which three IPv6 overlay tunnel statements are true? (Choose three.)   A.       Overlay tunnels can only be configured between border routers capable of supporting IPv4 and IPv6. B.       Overlay tunnels can be configured between border routers Read more [...]
Ensurepass  QUESTION 251 Refer to the exhibit.   Which two statements are correct regarding the routes to be redistributed into OSPF? (Choose two.)   A.  The network 192.168.1.0 will be allowed and assigned a metric of 100. B.  The network 192.168.1.0 will be allowed and assigned a metric of 200. C.  All networks except 10.0.0.0/8 will be allowed and assigned a metric of 200. D.  The network 172.16.0.0/16 will be allowed and assigned a metric of 200. E.  The Read more [...]
Ensurepass  QUESTION 241 Which statement describes the difference between a manually configured IPv6 in IPv4 tunnel versus an automatic 6to4 tunnel?   A.       A manually configured IPv6 in IPv4 tunnel allows multiple IPv4 destinations. B.       An automatic 6to4 tunnel allows multiple IPv4 destinations. C.       A manually configured IPv6 in IPv4 tunnel does not require dual-stack (IPv4 and IPv6) Read more [...]
Ensurepass  QUESTION 231 To enable BGP tunneling over an IPv4 backbone, the IPv4 address 192.168.30.1 is converted into a valid IPv6 address. Which three IPv6 addresses are acceptable formats for the IPv4 address? (Choose three.)   A.       192.168.30.1:0:0:0:0:0:0 B.       0:0:0:0:0:0:192.168.30.1 C.       ::192.168.30.1 D.      C0A8:1E01:: E.       Read more [...]
Ensurepass  QUESTION 221 When an IPv6 enabled host boots, it sends a router solicitation (RS) message. An IPv6 router responds with a router advertisement (RA). Which two items are contained in the RA? (Choose two.)   A.       IPv6 address for the host B.       lifetime of the prefix C.       prefixes for the link D.      keepalive timers E.       Read more [...]
Ensurepass  QUESTION 211 What happens when an IPv6 enabled router running 6to4 must send a packet to a remote destination and the next hop is the address of 2002::/16?   A.       The IPv6 packet has its header removed and replaced with an IPv4 header B.       The IPv6 packet is encapsulated in an IPv4 packet using an IPv4 protocol type of 41 C.       The IPv6 packet is dropped because that destination Read more [...]
EnsurepassQUESTION 201 What technique should be used on BGP edge routers to prevent a multi-homed autonomous system from becoming a transit system?   A.      Advertise with a high MED value all networks that are discovered via external BGP. B.      Set the no-export community attribute on all networks that are advertised externally. C.      Remove the AS-Path information on all routes in the BGP table prior to advertising Read more [...]
Ensurepass  QUESTION 191 Which two statements are true about IBGP neighbor relationships? (Choose two.) A.       An EGP or static routing is required between IBGP neighbors. B.       A full-mesh IBGP requires that neighbor relationships be established between all BGP enabled routers in the autonomous system. C.       IBGP neighbors must be in different autonomous systems. D.      Read more [...]