Ensurepass  QUESTION 151  (Topic 3)   The goal of the Converged Campus architecture is to provide a highly reliable infrastructure with sub second failover preventing any interruption of traffic on the network.   HMD primary benefits of this design goal? (Choose two)           A. in the event of a failure, no loss of connectivity or application availability will be experienced by the end user B. The architecture provides high performance Layer Read more [...]
Ensurepass  Topic 3, Volume C     QUESTION 139  (Topic 3)   Which SMLT resiliency feature uses the Soft Down option?   A. extended Control Packet limit (ext-CP limit) B. discards untagged frames C. Simple Loop Prevention Protocol (SLPP) D. virtual Link Aggregation Control Protocol (VLACP)   Answer: A       QUESTION 140  (Topic 3)   In a newly installed network the port LED on an Ethernet Routing Switch (ERS) 5500 is amber, Read more [...]
Ensurepass  QUESTION 101  (Topic 2)   A technician is setting up switch clustering using Split Multi-Link Trunking (SMLT).   Which link is configured between the aggregation switches?   A. Inter-switch trunk B. Multi-Link trunk C. Split MAC trunk D. LAG trunk   Answer: A     QUESTION 102  (Topic 2)   Which three functions describe VPFM? (Choose three.)   A. It is a network health at a glance tool. B. It can correlate faults, Read more [...]
Ensurepass  QUESTION 91  (Topic 2)         Consider the fallowing port conditions on an Ethernet Routing Switch (ERS) 8648GTRS 10/100/1000 Ethernet I/O module left LED -green Right LED - flashing green.   What is the status of the port?   A. The link speed is 100 Mbps. and the port is disabled. B. The link speed is 1000 Mbps, and the port is disabled C. The link speed is 100 Mbps. and the port is passing traffic. D. The link speed is 1000 Mbps. Read more [...]
Ensurepass  QUESTION 81  (Topic 2)   A technician has implemented Routed Split Multi-Link Trunking (RSMI I) edge design. After recovering power outage some clients could not communicate. It has been determined that only one of the core RSMLT switches has recovered.   What should have been done to prevent the loss communications?   A. Turn off the HoldDown timer. B. Increase the Holdup timer to 9999. C. Clear the peer IP and MAC addresses D. Set the VLAN to copy Read more [...]
Ensurepass  Topic 2, Volume B     QUESTION 71  (Topic 2)   The trace level 9 3 command accomplish?   A. It captures BGP events at a terse level. B. It captures packets copied to the CPU at a verbose level. C. It shows CPU utilization. D. It captures RCC IP events at verbose level.   Answer: B       QUESTION 72  (Topic 2)   What is the maximum number of Gigabit Ethernet ports on a single Ethernet Routing Switch (ERS) 8300 Input/Output Read more [...]
Ensurepass  QUESTION 41  (Topic 1)   When multiple VLANs are used, Dynamic Host Control Protocol (DHCP) relay is required to get the DHCP information from the end user VLAN DHCP server.   Which statement about how to enable DHCP relay is true?   A. The physical VLAN IP address is configured as the DHCP relay agent on each VLAN requiring a DHCP relay.         B. The IP address of the DHCP server is configured as the relay agent globally on all switches Read more [...]
Ensurepass  QUESTION 31  (Topic 1)   The IEEE 802.1aq virtualized service standard supports two modes of operation for the implementation of shortest path Bridging. Which mode is supported in the Avaya VENA Enterprise Fabric solution?   A. Provider link state bridging (PLSB) B. Shortest Path Bridging Mac-In-Mac (SPBM) C. Shortest Path Bridging VID (SPBV)         D. Shortest Path Bridging SID (SPBS)   Answer: C     QUESTION 32  (Topic Read more [...]
Ensurepass  QUESTION 21  (Topic 1)         RSMLT Edge is enabled globally on two ERS 8800 switches. After recovering from a power outage some clients cannot communicate. A technician determined that only one of the core switches has recovered.   What should the technician check to ensure that this loss of communication does not occur in the event of a future power outage or other failure?   A. Turn off the Hold Up timer on both core switches. B. Increase Read more [...]
Ensurepass  QUESTION 11  (Topic 1)   What is the underlying dynamic link state routing protocol used for the implementation of the Avaya Enterprise Fabric?   A. OSPF B. OSPFv3 C. IS-IS D. SPBV   Answer: B     QUESTION 12  (Topic 1)   A technician wants to control the routes being added to the routing table from the BGP routing table. Which statement describes how to do this?   A. BGP accept filters are applied to all routes from Read more [...]
Ensurepass  Topic 1, Volume A     Exam A   QUESTION 1  (Topic 1)   Which types of topologies are supported in the implementation of the Avaya Enterprise Fabric? (Choose three)   A. SPB Layer 2 VSN B. SPB GRT shortcuts C. SPB GRT 3 VSN D. SPBv VSN   Answer: ABD     QUESTION 2  (Topic 1)   When configuring an Ethernet Routing Switch (ERS) 8000 redundant installation for warm standby, which protocol is used to give the fastest Read more [...]