Ensurepass  QUESTION 231 A network administrator receives an error message while trying to configure the Ethernet interface of a router with IP address Which statement explains the reason for this issue?   A.       VLSM-capable routing protocols must be enabled first on the router. B.        This address is a network address. C.        This address is a broadcast address D.       Read more [...]
Ensurepass  QUESTION 221 Refer to the exhibit. What commands must be configured on the 2950 switch and the router to allow communication between host 1 and host 2? (Choose two.)     A.       Router(config)# interface fastethernet 0/0 Router(config-if)# ip address Router(config-if)# no shut down   B.        Router(config)# interface fastethernet 0/0 Router(config-if)# no shut down Router(config)# Read more [...]
Ensurepass  QUESTION 191 Refer to the exhibit. At the end of an RSTP election process, which access layer switch port will assume the discarding role?     A.       Switch3, port fa0/1 B.        Switch3, port fa0/12 C.        Switch4, port fa0/11 D.       Switch4, port fa0/2 E.        Switch3, port Gi0/1 F.        Read more [...]
Ensurepass  QUESTION 201 Which statement about IPv6 is true?   A.       Addresses are not hierarchical and are assigned at random. B.        Only one IPv6 address can exist on a given interface. C.        There are 2.7 billion addresses available. D.       Broadcasts have been eliminated and replaced with multicasts.   Correct Answer: D       Read more [...]
Ensurepass  QUESTION 211 Refer to the exhibit. Given the output for this command, if the router ID has not been manually set, what router ID will OSPF use for this router?   A. B. C. D.   Correct Answer: C     QUESTION 212 Which command can be used from a router Read more [...]
Ensurepass  QUESTION 181 Which address is the IPv6 all-RIP-routers multicast group address that is used by RIPng as the destination address for RIP updates?   A.       FF02::6 B.        FF02::9 C.        FF05::101 D.       FF02::A   Correct Answer: B     QUESTION 182 Which command shows your active Telnet connections?   A.       Read more [...]
Ensurepass  QUESTION 171 Which term describes a spanning-tree network that has all switch ports in either the blocking or forwarding state?   A.       converged B.        redundant C.        provisioned D.       spanned   Correct Answer: A     QUESTION 172 Which IPv6 address is the all-router multicast group?   A.       Read more [...]
Ensurepass  QUESTION 161 Which IPv6 routing protocol uses multicast group FF02::9 to send updates?   A.       static B.        RIPng C.        OSPFv3 D.       IS-IS for IPv6 Correct Answer: B     QUESTION 162 On which options are standard access lists based?   A.       destination address and wildcard mask B.        Read more [...]
Ensurepass  QUESTION 141 Refer to the exhibit. Which address range efficiently summarizes the routing table of the addresses for router Main?     A. B. C. D.   Correct Answer: B     QUESTION 142 Which two data link layers are supported by Cisco Read more [...]
Ensurepass  QUESTION 151 What are three benefits of implementing VLANs? (Choose three.)   A.       A higher level of network security can be reached by separating sensitive data traffic from other network traffic. B.        A more efficient use of bandwidth can be achieved allowing many physical groups to use the same network infrastructure. C.        A more efficient use of bandwidth can Read more [...]
Ensurepass  QUESTION 131 Refer to the exhibit. A technician is testing connection problems in the internetwork. What is the problem indicated by the output from HostA?     A.       The routing on Router2 is not functioning properly. B.        An access list is applied to an interface of Router3. C.        The Fa0/24 interface of Switch1 is down. D.       Read more [...]